Euphonix ML530 Instruction Manual download pdf (Page 81)

System 5 Digital Audio Mixing System Operation Manual CM401 Master Section

To select the same meter configuration for multiple Strips, press another Strip’s Wave

key after configuring the first Strip. Because each meter’s signal is automatically incre-

mented by one, set the lowest numbered Strip first and then set additional Strips con-

secutively. For the dual meter example above, pressing Strip 2’s Wave key assigns

Group Bus 2 to the upper meter and Strip 2’s fader to the bottom meter. If Strip 3’s

Wave key was pressed instead of Strip 2, Group Bus 2 would still be assigned to Strip

3’s upper meter.

5.4.2 Master Section Meters

Figure 5-12 Master section meters showing 5.1-channel CR and Aux Busses 1–8

The TFT screen above the center section shows two meters, one above another. The up-

per meter automatically shows the selected monitor output format. For example, if the

Control Room monitors Mix Bus A and it is a 5.1-channel format, the meter automati-

cally displays 5.1 channels.

The lower meter automatically displays whatever is currently assigned to the Bus Mas-

ter Strip: Aux, Mix, or Group Masters, Mon A, B, C, D, or Solo Master. The meter dis-

plays the eight meters corresponding to the Bus Master knobset. If there are more than

eight masters, use the WX keys on the Bus Master Strip to change pages. For example,

if Group Bus Masters 9–16 are on the knobset, the meters display these automatically.

Press the Mon A–D Source or the Solo Ctrl switches to meter these signals on the

lower meter.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 213 214

No comments

Euphonix ML530 Instruction Manual Page 81