Euphonix ML530 Instruction Manual download pdf (Page 109)

System 5 Digital Audio Mixing System Operation Manual Channels and Strips

109

8.3.2 Channel Processor Order

Enter the configuration mode as described in Section 8.3 on page 107. Press the cfg X

key to display the processor order page. The current order is indicated by the knob dis-

play (top = first). To change the order:

1. Press the knob switch for the processor to re-order.

The knob LED flashes and the processor order is displayed on the TFT screen

above the Strip. The fader, which becomes the controller to select the order,

jumps to a position that reflects the current order.

2. Move the fader up/down to select that processor’s new position.

The screen changes to reflect the new order.

Figure 8-9 Changing processor order

3. When that processor’s position is correct, press the fader Select/Punch key

(above the Wave key) to accept the new order.

The knob display changes only after pressing the Select/Punch key.

Press the switch next to the Channel On key to abort the selection.

8.3.3 Insert Point

Each channel can have an insert point with a send and return that can be patched with

PatchNet. The insert point can be anywhere among the six processors (Delay, Metering,

EQ, Filters, Dynamics, and Fader) and can be considered as another processor.

The insert point can be switched in/out using the Ins In key next to the Strip’s function

keys or from the third Input knobset page.

bort selection

ccept selection

Wave key

Fader scrolls

through

list

1 2 ... 104 105 106 107 108 109 110 111 112 113 114 ... 213 214

No comments

Euphonix ML530 Instruction Manual Page 109