Euphonix Modular I/O Specifications download pdf (Page 14)

Modular I/O Configuration Guide14

Synchronization

To configure the frame for synchronization:

1 To avoid damaging analog circuitry, make sure the AC power is off before beginning the installation.

2 Install SY983 Sync HD #1 in a red reserved slot and set as Master.

3 Install SY983 Sync HD #2 in a red reserved slot and set as Slave.

Control

To configure remote control, use the FC972 Remote to set the following parameters:

1 Set the IP Address range to 192.168.0.157~159/255.255.255.0

2 Set the Gateway to 192.168.0.1 This gateway permits configuration by the console system computer.

Module CAN IDs

Set the CAN ID of each module to match the table below.

See “FC972 Remote” on page 49 for details.

This frame does not require console control for mic preamps. Therefore, IP Address range 192.168.0.150~156 is skipped.

See each module’s section in Part III to learn how to set its CAN ID.

IO94 Frame

Module CAN ID

MM935 #1 0

MM935 #2 1

DD915 #1 2

DD915 #2 3

DD915 #3 4

DD915 #4 5

DD915 #5 6

DD915 #6 7

DE901 #1 8

DE901 #2 9

HD944 #1 10

HD944 #2 11

HD944 #3 12

HD944 #4 13

HD944 #5 14

HD944 #6 15

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 169 170

No comments

Euphonix Modular I/O Specifications Page 14