Euphonix Modular I/O Specifications download pdf (Page 133)

Chapter 11: Dolby D/E Modules 133

Using the CAN Address switches on the FC972 or SY983 is an older method of setting the Frame ID. An explicit CAN Address must

be set only when employing a hardware CAN-BUS remote controller to configure frames. In System 5, the Frame ID is set with

the FC972’s IP Address for configuration using a web browser interface.

To set the CAN ID in range 0–15:

1 Set SW1-B to OFF.

2 Use the CAN Rotary Switch to set the CAN ID.

To set the CAN ID in range 16–31:

1 Set SW1-B to ON.

2 Use the CAN Rotary Switch to set the CAN ID.

Status LEDs

Green OK

Red Bad

Flashing The module is in focus of the frame controller

Green Under GUI control

Dolby D LEDs

Red Reading a proper Dolby D signal

Off Dolby D decoding error

Dolby E LEDs

Blue Reading a proper Dolby E signal

Off Dolby E decoding error

1 2 ... 128 129 130 131 132 133 134 135 136 137 138 ... 169 170

No comments

Euphonix Modular I/O Specifications Page 133