Euphonix SH612 User Manual download pdf (Page 9)

Euphonix SH612 Studio Hub User Guide Getting Started

1.2 Modes of Operation

The SH612 has two main standalone modes of operation, with different firmware load-

ed for each. The firmware can be flashed in the field if the other mode is desired (typi-

cally it is decided on ordering and the firmware is uploaded at the factory). The two

modes are as follows:

Standard Operation

The SH612 acts as a standalone routing hub for all MADI sources/destinations. Using

the standalone MADI routing application, routes in and out of the Studio Hub can be

created, saved, and recalled as necessary. For more information, see page 19.

ES Control

With the ES Bus capable firmware (the second bootup screen shows ES-Control

Equipped Edition) the SH612 can be controlled by various video routing systems using

the standard ES Bus serial protocol. This negates the need for a separate audio router

for the video routing system, useful in situations with limited space and weight consid-

erations (OB trucks, small studios, etc). Integration for each video routing system is

documented in its own chapter - see the table of contents.

1.3 Setting the Control Port

For both modes, the SH612 must be set to read control messages from its female DE-9

Control port (RS-422 serial), instead of its IEEE-1394 ports (previously used for the

now-discontinued Euphonix R-1 recorder).

First disconnect all cables from the Control and IEEE-1394 ports (the unit does not al-

low Control port settings modifications with cables connected, to avoid accidental

changes). Then proceed as follows:

1. Power on the SH612 and press Select once to enter the Main Menu.

If the SH612 does not display its Main Menu, press the Escape key several

times until the status display is shown, then press Select again.

2. Turn the SpinKnob to highlight Utility Menu and press Select.

3. Turn the SpinKnob to highlight Control Port and press Select.

4. Check that the LCD displays Control Port = RS422 at the top. It not, turn the

SpinKnob to highlight RS422 (at bottom of LCD) and press Select.

5. Press Escape twice to show status again.

6. If you changed the setting, reboot the SH612 to implement the control port

change.

7. Reconnect the control cables.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 43 44

No comments

Euphonix SH612 User Manual Page 9