Euphonix MC Media Application Controller Installation Guide download pdf (Page 5)

Media Application Controller Multiple DAW Install Guide

Chapter 1: Hardware Connections and MC Client Setup

Schematics and parts are listed for each DAW setup in Appendix A: DAW Parts List

and Schematics.

1.1 Connect the MC

1. Unpack the MC from its packaging and select a place to put it. The MC should

go on a hard flat surface in order to allow proper ventilation. (System 5-MC has

its own frame for the MC and CM408T modules).

NOTE: The MC and CM408T modules require sufficient ventilation space on the bot-

tom. The MC has detachable feet for standalone users without a System 5

frame, but the CM408T modules do not. If you do not use a System 5 frame,

you MUST have at least 1 inch of clearance under the CM408T modules and

MC or damage to the units may occur.

Use Figure 1-1 as a reference to connect the MC to its components.

Figure 1-1 MC Rear Panel

2. Plug the power supply into the DC In port on the right side as you look at the

rear panel.

Be careful plugging this in as the connector has easily-bent pins. When the pins

are seated, twist the ring on the connector’s side until it locks. Do not turn on

the MC yet; network configuration must be completed first.

WARNING: Attach power supply to the MC BEFORE plugging into AC power or the

unit may be damaged.

LANLAN DC INTALKBACK MIC

VGA KEYBOARD USB

SWITCH HEADPHONES

FOOT

USB Talkback Mic Output LAN Headphone DC In

VGA and

Keyboard

Foot Switch

1 2 3 4 5 6 7 8 9 10 ... 28 29

No comments

Euphonix MC Media Application Controller Installation Guide Page 5